9-2 (24) 2UEA001270 Rev. F ACS2000 User manual
Chapter 9 - CDP control panel
9.2 Overview of CDP control panel functions
The CDP control panel serves as the basic user interface for operating
and monitoring the drive when the local operating mode has been
selected.
The CDP control panel can be attached to or detached from the drive
without having to switch off the auxiliary power supply first.
Using the CDP control panel it is possible to:
• enter start-up data,
• control the drive with a reference value and start, stop and direction
commands,
• display actual values (three values can be read simultaneously),
• display and adjust parameters,
• display information on the most recent 64 fault events.
9.3 Overview of CDP control panel modes
The CDP control panel provides the following modes:
• Identification mode
See section 9.3.1 Identification mode for further information.
• Actual signal display mode
See section 9.3.2 Actual signal display mode for further information.
• Parameter mode, selected by the PAR key
See section 9.3.3 Parameter mode for further information.
• Function mode, selected by the FUNC key
See section 9.3.4 Function mode for further information.
• Drive selection mode, selected by the DRIVE key
See section 9.3.5 Drive selection mode for further information.
To Next Page
Loading...
Need help?
General
