The ACS850 control panel 33
îš„ Changed Parameters
In the Changed Parameters mode, you can:
• view a list of all parameters that have been changed from the macro default
values
• change these parameters
• start, stop, change the direction and switch between local and remote control.
How to view and edit changed parameters
Step Action Display
1. Go to the Main menu by pressing if you are in the
Output mode.
Otherwise press repeatedly until you get to the
Main menu.
2. Go to the Changed Parameters mode by selecting
CHANGED PAR on the menu with keys and
, and pressing .
If there are no changed parameters in the history,
corresponding text will be shown.
If parameters have been changed, a list of them is
shown. Select the changed parameter on the list with
keys and . The value of the selected
parameter is shown below it.
3. Press to modify the value.
4. Specify a new value for the parameter with keys
and .
Pressing the key once increments or decrements the
value. Holding the key down changes the value faster.
Pressing the keys simultaneously replaces the displayed
value with the default value.
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT ENTER
00:00
MAIN MENU 1
LOC
00:00
No parameters
MESSAGE
LOC
9906 Mot nom current
3.5 A
9907 Mot nom voltage
9908 Mot nom freq
9909 Mot nom speed
CHANGED PAR
EXIT
EDIT
00:00
LOC
9906 Mot nom current
PAR EDIT
3.5 A
CANCEL SAVE
00:00
LOC
9906 Mot nom current
PAR EDIT
3.0 A
CANCEL SAVE
00:00
LOC
To Next Page
Loading...
Need help?
General
