Save changes
Increase value
Decrease value
Cancel edit
Min/max value
Last digit
modified
Next position
Select option
Previous option
in the list
Next option in list
Cancel editing
Slider indicates position
within the given options
Selected
option
Adjusting Parameters
Adjusting a numerical value
This type of dialog allows a numerical value to be specified within the given limits. The single digits must be defined from right to
left. If the last digit was reached the right hot key changes from 'Next' to 'Save'. When pressing 'Save' the specified value is stored
in the UMC. The mask can be exited at any time with the Cancel button (left hot key). In this case the changes are discarded.
The following example shows how to set the nominal motor current I
e1
.
To change the digit use the up/down keys. As it is not possible to enter a value outside the given limits start editing the first digit
by pressing the up button. If you reach 10, a 0 is displayed in the first digit and a 1 in the second digit. Press the left hot key now to
go to the next digit.
Selecting an option from a list
This type of dialog allows an item to be selected from a given list of options. With the up/down keys you can scroll through the list.
The slider on the right shows the current position within the list. Pressing 'Select' chooses the currently marked item (inverted).
Pressing 'Cancel' exits the dialog and discards the selection.
108
To Next Page
Loading...
Need help?
General
