PowerPower
UMC with
PDP32
PROFIBUS
Master
UMC with
PDP32
Using the UMC100.3 in a PROFIBUS DP Network
The most commonly used one is the ‘daisy chain’ topology where one device is connected after the other.
They define block parameterisation, configuration, cyclic data exchange and diagnosis information exchange. DP-V0 only al-
lows the complete parameter set to be written in one block. The bus master sends the parameter block to the slave during
powering up of the slave/device. Some control systems also allow sending the parameter block during normal operation.
expansions. These acyclic services are inserted into special telegrams during ongoing cyclical bus operation and thus ensure
PDP32 communication interface.
and different possiblities to use it is available in the PDP32 manual.
—
PROFIBUS Line with UMC100.3 and PDP32.
Use standard PROFIBUS cable for wiring. It is also possible to mount the PDP32 remote from
the UMC. See PDP32 manual for more information. Instead of directly connecting the PROFIBUS
cable to the PDP32 X4 terminals also DSUB-9 connectors can be used and connected to X3
28
To Next Page
Loading...
Need help?
General
