Parameter Organisation
-
vide the link the menu structure i.e. where it is displayed.
• Motor Management lists all parameters related to motor management i.e. starting and stopping the motor and the control function
•
• Communication lists parameters related to the fieldbus communication
•
•
• Function block lists all parameters related to a specific function block.
Motor Management Parameters
Parameter
Number
Parameter Description, Explanations Options Adjustable via
General motor management parameters
Control function
,
All
Rev lock-out time Interlocking time before a start command in the opposite
direction is accepted
All
mode
The UMC switches from star to delta either after a defined time
All
(Time Limit
Time switching from star to delta. If the changeover mode is set
to 'current' this time defines when the motor current must be
opposite end position.
All
Resistive Load Other than motor load connected All
Fault output ,
All
Number of phases Change from three phases to single phase load
All
Checkback Selection of the checkback supervision method.
,
All
a digital input.
,
All
Enable custom
logic
,
All
123
To Next Page
Loading...
Need help?
General
