- 77 -
000513AG
Display access and settings
Once the inverter has been commissioned, it is possible to congure the
inverter by accessing the "Settings" Menu directly from the display. The
following are the main adjustable parameters (see the section on “Menu
descriptions”)
• RS485 address: setting required in the case of system monitoring via
the RS485 line
• Vstart: setting required if requested by the congurator during the sys-
tem sizing procedure ("Vstart" parameter)
• MPPT scan: allows maximum power point tracking to be carried out
with settable sensitivity and time interval (“E/D MPPT Scan” parameter).
• Reactive power feed-in setting (where present): setting necessary
for managing the different ways of feeding reactive power into the grid
(“Reactive Power” parameter)
• Active power limitation setting (where present): setting necessary
to set a limit on the active power supplied by the inverter (“Power Limit”
parameter)
Скачано с сайта интернет магазина https://axiomplus.com.ua/
To Next Page
Loading...
Need help?
General