Which Cleaning Procedure should I use ? Cleaning Instructions
Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition 433
Which Cleaning Procedure
should I use ?
Light dirt
If you just want to clean away light dirt, observe the following procedure
for all devices:
• Use compressed air to blow away large particles.
• Clean the device with a dry cotton swab.
• Use compressed air to blow away any remaining filament left by the swab.
Heavy dirt
If the above procedure is not enough to clean your instrument, follow one
of the procedures below. Please consult “Cleaning Instructions for this
Instrument” on page 421 for the procedure relevant for this instrument.
If you are unsure of how sensitive your device is to cleaning, please
contact the manufacturer or your sales distributor
To Next Page
Loading...
Need help?
General
