Additional Information How to Connect an External Monitor
80 Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Sixth Edition
How to Connect an External
Monitor
You can connect a standard VGA monitor to the Agilent 8164A/B
Lightwave Measurement System and the Agilent 8166B Lightwave
Multichannel System. This is a useful feature for making presentations or
for training courses.
Figure 40 Rear Panel of the Agilent 8164B Lightwave Measurement System
• Place your monitor on a flat sturdy surface.
• Before you make any connections make sure the Lightwave Measurement
System and monitor are turned off.
• Connect the power cable to the video input on the back of your monitor.
Tighten the thumbscrews on the plug.
• Connect the video cable (it has a 15-pin plug) to the video outlet on the back of
the Lightwave Measurement System. Tighten the thumbscrews on the plug.
• Connect the power cord to the display.
• Plug the power cord into the power outlet.
You cannot connect a monitor to the Agilent 8163A/B Lightwave
Multimeter or Agilent 8166A Lightwave Multichannel system.
NOTE
Refer to the user’s guide that came with your monitor, if necessary, to
locate your monitor’s output and input ports.
NOTE
To Next Page
Loading...
Need help?
General
