Rockwell Automation Publication 520-UM001A-EN-E - February 2013 47
Chapter 2
Start Up
This chapter describes how to start up the PowerFlex 525 drive. To simplify drive
setup, the most commonly programmed parameters are organized in a single
Basic Program Group.
Prepare for Drive Start-Up
Before Applying Power to the Drive
1. Confirm that all inputs are connected to the correct terminals and are
secure.
2. Verify that AC line power at the disconnect device is within the rated value
of the drive.
3. Verify that any digital control power is 24 volts.
For information on... See page...
Prepare for Drive Start-Up 47
Display and Control Keys 49
Viewing and Editing Parameters 50
Drive Programming Tools 51
Smart Start-Up with Basic Program Group Parameters 52
LCD & Scrolling Description 53
USB 54
Read the General Precautions section before proceeding.
ATTENTION: Power must be applied to the drive to perform the following
start-up procedures. Some of the voltages present are at incoming line
potential. To avoid electric shock hazard or damage to equipment, only
qualified service personnel should perform the following procedure.
Thoroughly read and understand the procedure before beginning. If an event
does not occur while performing this procedure, Do Not Proceed. Remove All
Power including user supplied control voltages. User supplied voltages may
exist even when main AC power is not applied to the drive. Correct the
malfunction before continuing.
To Next Page
Loading...
Need help?
General
