15
use and maintenance Scarabeo 500
INSTRUMENTS AND INDICATORS TABLE
When the key is turned to ON “ ”, all warning lights, the dashboard lights and the segments of the three displays
come on for an instrumentation check-up and go out after three seconds.
CAUTION
Description Function
Right indicator repeater light ()
Blinks when the right direction indicator is on.
Left indicator repeater light
()
Blinks when the left direction indicator is on.
High beam light
() Comes on when the high beam is on or when you flash the high beam (PASSING ).
Engine oil pressure light
() Comes on briefly each time the ignition switch is set to “ ” with the engine stopped. Doubles as LED test
light.
The light must go out as soon as engine is fired.
If the light comes on during normal engine operation, it means that engine
oil pressure in the circuit is too low. Stop the engine immediately and
contact an aprilia Official Dealer.
Side stand light
()
Comes on when the side stand is down.
When the side stand is down, the warning light comes on and engine
starting is inhibited.
EFI (Electronic Fuel Injection) light Comes on for about three seconds when the ignition switch is set to “ ” with the engine stopped. Provides a
fuel injection system test. The light must go out when the engine has started.
If the EFI light comes on during normal engine operation, it means that there is a
fault in the electronic fuel injection system. Stop the engine immediately and
contact an aprilia Official Dealer.
ABS (Anti-Lock Braking System)
light
()
(where fitted). Anti-lock braking system check-up. Comes on in the event of a malfunction.
If the light comes on during normal engine operation, it means that there is a
failure in the anti-lock braking system. Stop the engine immediately and
contact an aprilia Official Dealer.
Anti-theft device (immobilizer) light (where fitted). Blinks when the engine is off as a deterrent to prevent theft.
Indicates that the anti-theft system is operating.
CAUTION
CAUTION
CAUTION
ABS
CAUTION