MediaPack SIP
MediaPack SIP User’s Manual 104 Document #: LTRT-65405
Table 5-22: Caller ID ini File Parameter
Parameter Name in ini File Parameter Format
CallerDisplayInfoX
CallerDisplayInfo<channel> = <Caller ID string>,<Restriction>
0 = Not restricted (default).
1 = Restricted.
For example:
CallerDisplayInfo0 = Susan C.,0
CallerDisplayInfo2 = Mark M.,1
Note 1: The numbering of channels starts with 0.
Note 2: This parameter can appear up to eight times for 8-port gateways,
and up to 24 times for MP-124.
5.5.8.4 Generate Caller ID to Tel
The Generate Caller ID to Tel table is used to enable or disable (per port) the Caller ID
generation (for FXS gateways) and detection (for FXO gateways). If a port isn’t configured, its
Caller ID generation / detection are determined according to the global parameter
‘EnableCallerID’ (described in Table
5-6).
¾ To configure the Generate Caller ID to Tel Table, take these 5 steps:
1. Open the ‘Generate Caller ID to Tel’ screen (Protocol Management menu > Endpoint
Settings > Generate Caller ID to Tel option); the ‘Generate Caller ID to Tel’ screen is
displayed.
Figure
5-24: MediaPack FXS Generate Caller ID to Tel Screen
2. In the ‘Caller ID’ field, select one of the following:
¾ Enable – Enables Caller ID generation (FXS) or detection (FXO) for the specific port.
¾ Disable – Caller ID generation (FXS) or detection (FXO) for the specific port is disabled.
¾ Empty – Caller ID generation (FXS) or detection (FXO) for the specific port is determined
according to the parameter ‘EnableCallerID’ (described in Table 5-6).
3. Repeat step 2 for each port.
4. Click the Submit button to save your changes.
To Next Page
Loading...
Need help?
General
