MediaPack SIP User’s Manual 5. Configuring the MediaPack
Version 4.6 115 June 2005
4. To save the changes so they are available after a power fail, refer to Section 5.9 on page
161.
Table 5-28: Network Settings, IP Settings Parameters
(continues on pages 128 to 131)
Parameter Description
IP Networking Mode
[EnableMultipleIPs]
Enables / disables the Multiple IPs mechanism.
Single IP Network [0] (default).
Multiple IP Network [1].
For detailed information on Multiple IPs, refer to Section
9.6 on page 196.
IP Address IP address of the gateway.
Enter the IP address in dotted format notation, for example 10.8.201.1.
Note 1: A warning message is displayed (after pressing the button ‘Submit’) if the
entered value is incorrect.
Note 2: After changing the IP address and pressing the button ‘Submit’, a prompt
appears indicating that for the change to take effect, the gateway is to be reset.
Subnet Mask Subnet mask of the gateway.
Enter the subnet mask in dotted format notation, for example 255.255.0.0
Note 1: A warning message is displayed (after pressing the button ‘Submit’) if the
entered value is incorrect.
Note 2: After changing the subnet mask and pressing the button ‘Submit’, a prompt
appears indicating that for the change to take effect, the gateway is to be reset.
Default Gateway Address IP address of the default gateway used by the gateway.
Enter the IP address in dotted format notation, for example 10.8.0.1.
Note 1: A warning message is displayed (after pressing the button ‘Submit’) if the
entered value is incorrect.
Note 2: After changing the default gateway IP address and pressing the button
‘Submit’, a prompt appears indicating that for the change to take effect, the gateway
is to be reset.
For detailed information on multiple routers support, refer to Section 9.4 on page
194.
OAM Network Settings (available only in Multiple IPs mode)
IP Address
[LocalOAMIPAddress]
The gateway’s source IP address in the OAM network.
The default value is 0.0.0.0.
Subnet Mask
[LocalOAMSubnetMask]
The gateway’s subnet mask in the OAM network.
The default subnet mask is 0.0.0.0.
Default Gateway Address
[LocalOAMDefaultGW]
N/A.
Use the IP Routing table instead (Advanced Configuration > Network Settings).
Control Network Settings (available only in Multiple IPs mode)
IP Address
[LocalControlIPAddress]
The gateway’s source IP address in the Control network.
The default value is 0.0.0.0.
Subnet Mask
[LocalControlSubnetMask]
The gateway’s subnet mask in the Control network.
The default subnet mask is 0.0.0.0.
Default Gateway Address
[LocalControlDefaultGW]
N/A.
Use the IP Routing table instead (Advanced Configuration > Network Settings).
Media Network Settings (available only in Multiple IPs mode)
IP Address
[LocalMediaIPAddress]
The gateway’s source IP address in the Media network.
The default value is 0.0.0.0.
Subnet Mask
[LocalMediaSubnetMask]
The gateway’s subnet mask in the Media network.
The default subnet mask is 0.0.0.0.
Default Gateway Address
[LocalMediaDefaultGW]
The gateway’s default gateway IP address in the Media network.
The default value is 0.0.0.0.
DNS Settings
DNS Primary Server IP
[DNSPriServerIP]
IP address of the primary DNS server.
Enter the IP address in dotted format notation, for example 10.8.2.255.
Note: To use Fully Qualified Domain Names (FQDN) in the Tel to IP Routing table,
you must define this parameter.
DNS Secondary Server IP
[DNSSecServerIP]
IP address of the second DNS server.
Enter the IP address in dotted format notation, for example 10.8.2.255.
To Next Page
Loading...
Need help?
General
