MediaPack SIP User’s Manual 5. Configuring the MediaPack
Version 4.6 97 June 2005
5.5.6 Configuring the Endpoint Phone Numbers
From the Endpoint Phone Numbers screen you can enable and assign telephone numbers, hunt
groups (optional) and profiles to the VoIP gateway ports.
¾ To configure the Endpoint Phone Numbers table, take these 4 steps:
1. Open the ‘Endpoint Phone Numbers Table’ screen (Protocol Management menu >
Endpoint Phone Numbers); the ‘Endpoint Phone Numbers Table’ screen is displayed.
Figure
5-19: Endpoint Phone Number Table Screen
2. Configure the Endpoint Phone Numbers according to Table
5-18. You must enter a number
in the Phone Number fields for each port that you want to use.
3. Click the Submit button to save your changes, or click the Register or Un-Register buttons
to save your changes and to register / unregister to a Proxy / Registrar.
4. To save the changes so they are available after a power fail, refer to Section
5.9 on page
161.
Table
5-18: Endpoint Phone Numbers Table
Parameter Description
Channel(s) The numbers (1-8) in the Channel(s) fields represent the ports on the back of the VoIP
gateway.
To enable a VoIP gateway channel, you must enter the port number on this screen.
[n-m] represents a range of ports. For example, enter [1-4] to specify the ports from 1 to
4.
Phone Number In each of the Phone Number fields, enter the telephone number that is assigned to that
channel.
For a range of channels enter the first number in an ordered sequence.
These numbers are also used for port allocation for IP to Tel calls, if the hunt group’s
‘Channel Select Mode’ is set to ‘By Phone Number’.
To Next Page
Loading...
Need help?
General
