MediaPack SIP
MediaPack SIP User’s Manual 24 Document #: LTRT-65405
2.1.1.1 MP-1xx Front Panel Buttons
Table 2-1 lists and describes the front panel buttons on the MP-1xx.
Table
2-1: Front Panel Buttons on the MP-1xx
Type Function Comment
Reset the MP-1xx
Press the reset button with a paper clip or any other similar
pointed object, until the gateway is reset.
Reset button
Restore the MP-1xx parameters to
their factory default values
Refer to Section
10.1 on page 201.
2.1.1.2 MP-1xx Front Panel LEDs
Table 2-2 lists and describes the front panel LEDs on the MP-1xx.
Note: MP-1xx (FXS/FXO) media gateways feature almost identical front panel
LEDs; they only differ in the number of channel LEDs that correspond to the
number of channels.
Table 2-2: Indicator LEDs on the MP-1xx Front Panel
Label Type Color State Function
Green ON
Device Powered, self-test OK
Orange Blinking
Software Loading/Initialization
Ready
Device Status
Red ON
Malfunction
Green ON
Valid 10/100 Base-TX Ethernet connection
LAN
Ethernet Link
Status
Red ON
Malfunction
Green Blinking
Sending and receiving SIP messages
Control
Control Link
Blank
No traffic
Green Blinking
Transmitting RTP (Real-Time Transport Protocol)
Packets
Red Blinking
Receiving RTP Packets
Data
Packet Status
Blank -
No traffic
Offhook / Ringing for FXS Phone Port
Green ON
FXO Line-Seize/Ringing State for Line Port
Green Blinking
There’s an incoming call, before answering
Red ON
Line Malfunction
Channels
Telephone
Interface
Blank -
Normal
To Next Page
Loading...
Need help?
General
