MediaPack SIP User’s Manual 5. Configuring the MediaPack
Version 4.6 95 June 2005
5.5.5.3 IP Profile Settings
Use the IP Profile Settings screen to define up to four different IP Profiles. These Profiles are
used in the Tel to IP and IP to Hunt Group Routing tables to associate different Profiles to routing
rules. IP Profiles can also be used when working with Proxy server (set ‘AlwaysUseRouteTable’
to 1).
¾ To configure the IP Profile settings, take these 9 steps:
1. Open the ‘IP Profile Settings’ screen (Protocol Management menu > Profile Definitions
submenu > IP Profile Settings option); the ‘IP Profile Settings’ screen is displayed.
Figure
5-18: IP Profile Settings Screen
2. In the ‘Profile ID’ drop-down list, select the IP Profile you want to edit (up to four IP Profiles
can be configured).
3. In the ‘Profile Name’ field, enter a name that enables you to identify the Profile intuitively and
easily.
4. In the ‘Profile Preference’ drop-down list, select the preference (1-10) of the current Profile.
The preference option is used to determine the priority of the Profile. If both IP and Tel
profiles apply to the same call, the coders and other common parameters of the preferred
Profile are applied to that call. If the Preference of the Tel and IP Profiles is identical, the Tel
Profile parameters are applied.
Note: If the coder lists of both IP and Tel Profiles apply to the same call, an intersection of
the coders is performed (i.e., only common coders remain). The order of the coders is
determined by the preference.
5. Configure the Profile’s parameters according to your requirements. For detailed information
on each parameter, refer to the description of the screen in which it is configured as an
individual parameter.
6. In the ‘Coder Group’ drop-down list, select the coder group you want to assign to that Profile.
You can select the gateway’s default coders (refer to Section
5.5.1.3 on page 61) or one of
To Next Page
Loading...
Need help?
General
