Allow engine on support mo-
torcycle to run while jump-
starting.
Start engine of vehicle with dis-
charged battery in usual way;
if engine does not start, wait
a few minutes before repeat-
ing attempt in order to protect
starter motor and donor bat-
tery.
Allow both engines to run for
several minutes before discon-
necting the jump lead.
First disconnect the jump lead
from the negative terminal or
ground support point, then
from the positive terminal or
positive battery connection
point.
NOTICE
To start the engine, do not use
start sprays or similar items.
Install fairing side panel
( 111).
Battery
Maintenance instructions
Correct battery maintenance
combined with proper charging
and storage procedures extends
the battery's service life, and is
also required for warranty claims.
Compliance with the points be-
low is important in order to maxi-
mize battery life:
Keep the surface of the battery
clean and dry
Be sure to read and comply
with the instructions for charg-
ing the battery on the following
pages
Do not turn the battery upside
down
ATTENTION
Discharging of the connected
battery by the vehicle elec-
tronics (e.g. clock).
Total discharge of battery leading
to a rejection of warranty claims.
During riding breaks of more
than 4 weeks, connect a
trickle-charger to the battery.
Charging a connected
battery
with additional onboard
socket
OA
ATTENTION
Charging of the connected
battery on the battery termi-
nals.
Damage to the motorcycle's
electronics.
Disconnect the battery be-
fore charging on the battery
terminals.
8
108
z
Maintenance
To Next Page
Loading...
Need help?
General
