facility, preferably an authorized
BMW Motorrad retailer.
If you are unsure about the tire's
suitability for continued riding:
Do not continue riding.
Contact roadside service.
Tire inflation pressure
of both tires is outside
approved range
with Tire Pressure Control
(TPC/RDC)
OE
General warning light
flashes red.
Tire symbol with arrows
pointing upward and down-
ward is displayed.
Tire inflation pressures flash.
Possible cause:
The measured tire inflation pres-
sure of both tires is outside the
permissible tolerance.
Check tire for damage and
suitability for continued use.
Are the tires still suitable for driv-
ing:
WARNING
Tire inflation pressure is out-
side approved range.
Poorer handling characteristic of
the motorcycle.
Adapt your style of riding
accordingly.
Correct tire inflation pressure at
the next opportunity.
NOTICE
Before adjusting the tire inflation
pressure, observe the information
on temperature compensation
and on inflation pressure adjust-
ment in the chapter "Technology
in detail".
Have the tire checked for dam-
age at an authorized service
facility, preferably an authorized
BMW Motorrad retailer.
If you are unsure about the driv-
ability of the tires:
Do not continue riding.
Contact roadside service.
Transmission error
with Tire Pressure Control
(TPC/RDC)
OE
"" or ": " is indicated.
Possible cause:
The motorcycle's speed has not
exceeded the threshold of ap-
prox. 19 mph (30 km/h). The
TPC/RDC sensors do not send
their signal until after this speed
has been exceeded for the first
time ( 81).
Watch the TCP/RDC display
at a higher rate of speed. A
continuous error is only present
if the general warning light also
lights up. In this case:
3
36
z
Displays
To Next Page
Loading...
Need help?
General
