Bosch rexroth A4VSO 10 Series User Manual

62/72 Removal and replacement
BoschRexrothAG, axial piston variable pump A4VSO, RE 92050-01-X-B1/2019.08.23
11 Removal and replacement
DANGER
Risk of explosion and/or fire due to ignition of an explosive atmosphere or of
combustible dust!
Serious injury caused by blast pressure and fire may result.
▶ Only remove or replace the unit in a non-explosive atmosphere.
▶ The system operator is responsible for ensuring the appropriate ambient
conditions.
11.1 Required tools
Removal can beperformed using standard tools. No special tools are necessary.
11.2 Preparing for removal
1. Decommission theentire system asdescribed inthe instruction manual for
themachine orsystem.
–Relieve pressure inthe hydraulic system according tothe instructions
ofthemachine orsystem manufacturer.
–Make sure therelevant system components are depressurized and de-energized.
2. Secure theentire system against being re-energized.
11.3 Performing thedisassembly
Proceed asfollows toremove theaxial piston unit:
1. Verify that the hydraulic system is depressurized.
2. Allow theaxial piston unit tocool down until itcan beremoved without danger.
3. For below-reservoir installation, seal the connection to the reservoir or drain the
reservoir before removing the axial piston unit from the overall system.
4. Place adrip tray under theaxial piston unit tocollect any hydraulic fluid that
mayleak.
5. Disconnect thelines and collect theescaping hydraulic fluid inthe drip tray.
6. Remove theaxial piston unit. Use asuitable lifting device.
7. Completely drain theaxial piston unit.
8. Plug all openings.

Bosch rexroth A4VSO 10 Series Specifications

General

Brand	Bosch
Model	rexroth A4VSO 10 Series
Category	Water Pump
Language	English