ctrlX SAFETY "SafeMotion"
Instructions with regard to specific dangers
● For their individual application, the machine manufacturer and the system
installer have to
–
verify the applicability of the provided components and the specifications
made for their use in this application documentation,
–
synchronize the applicability with the safety regulations and standards
applicable for their application and to execute the required measures,
modifications and additions.
●
Commissioning of the provided components is prohibited until is has been
established that the machine or the system in which the components are
installed corresponds to the country-specific provisions, safety regulations
and standards of the application.
● Operation is only allowed when complying with the national EMC regulations
for the relevant application.
● For information about EMC-compliant installation, refer to the section on
EMC in the relevant application documentation.
● The system or machine manufacturer is responsible for compliance with the
limit values specified in the national regulations.
●
The technical data, connection and installation conditions of the compo-
nents are contained in the relevant application documentations and must be
complied with.
●
Country-specific laws and regulations must be observed.
4.1.3
Hazards due to incorrect use
● High electrical voltage and high operating current! Danger to life or serious
personal injury due to electric shock!
● High electrical voltage due to incorrect connection! Danger to life or per-
sonal injury due to electric shock!
●
Dangerous movements! Danger to life, serious personal injury or property
damage due to unintended motor movements!
●
Health hazard for persons with heart pacemakers, metal implants and
hearing aids in proximity to electric drive systems!
●
Risk of burns by hot housing surfaces!
● Risk of injury by improper handling! Personal injury by crushing, shearing,
cutting, hitting!
● Risk of injury by improper handling of batteries!
● Risk of injury by improper handling of pressurized lines!
4.2 Instructions with regard to specific dangers
4.2.1
Protection against contact with electrical parts and housings
This section concerns components of the electric drive and control system with
voltages of more than 50 volts.
Contact with parts conducting voltages above 50 volts can cause personal
danger and electric shock. When operating components of the electric drive
and control system, it is unavoidable that some parts of these components
conduct dangerous voltage.
High electrical voltage! Danger to life, risk of injury by electric shock or serious
personal injury!
●
Only qualified persons are allowed to operate, maintain and/or repair the
components of the electric drive and control system.
●
Follow the general installation and safety regulations when working on
power installations.
To Next Page
Loading...
Need help?
General
