● Risk of injury by improper handling of batteries!
● Risk of injury by improper handling of pressurized lines!
3.2.4 Explanation of Safety Symbols and Hazard Classification
The safety instructions describe the following hazard classification. The hazard
classification informs about the consequences resulting from non-compliance
with the safety instructions:
Safety symbol Signal
word
Hazard classification according to ANSI Z535.4-2002
Danger Death or serious injury will occur.
Warning Death or serious injury could occur.
Caution Minor or moderate injury or property damage may oc‐
cur.
Fig.3-1: Hazard classification (according to ANSI Z535.4-2002)
3.3 Instructions with Regard to Specific Dangers
3.3.1 Protection Against Contact with Electrical Parts and Housings
This section concerns components of the drive and control system
with voltages of more than 50 volts.
Contact with parts conducting voltages above 50 volts can cause personal
danger and electric shock. When operating components of the drive and control
system, it is unavoidable that some parts of these components conduct dan‐
gerous voltage.
16/135 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth MTA 200 | Project Planning Manual
Safety Instructions for Electric Drives and Controls
To Next Page
Loading...
Need help?
General
