2-32
Confidential
îš„ Error code 0E00
Communication between the panel PCB and the main PCB cannot be established at
machine startup.
îš„ Error code 0F00
The back cover sensor detected that the cover was open in duplex printing mode.
îš„ Error codes 1000 to 1D00
These errors do not usually occur during normal use. The possible causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
An unidentified error occurred.
---
Step Cause Remedy
1
Connection failure of the panel
PCB harness
Reconnect the panel PCB harness.
2 Panel PCB failure Replace the panel PCB ASSY.
3 Touch panel PCB failure Replace the touch panel PCB ASSY.
4 Main PCB failure Replace the main PCB ASSY.
Duplex Disabled
Close the Back Cover of the machine and put the Duplex Tray back in.
<User Check>
• Close the back cover.
• Set the duplex tray.
Step Cause Remedy
1
Connection failure of the back
cover sensor harness
Check the connection of the back cover sensor
harness, and reconnect it if necessary.
2
Back cover sensor attachment
failure
Reattach the back cover sensor.
3
Broken rib (on the right inside
the back cover) where the back
cover switch is pressed
Replace the back cover.
4 Damaged duplex tray Replace the duplex tray.
5 Back cover sensor failure Replace the back cover switch harness ASSY.
6 Main PCB failure Replace the main PCB ASSY.
---
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
To Next Page
Loading...
Need help?
General