Brother MFC-J2330DW Service Manual

3-91
Confidential
Assembling Note: Mount the Head/carriage unit, using the following steps.
1) When mounting a new Head/carriage unit, apply lubricant to the unit, as
specified in Section 5 "LUBRICATION" of this chapter.
2) When mounting the CR timing belt, insert it into the Head/carriage unit so that
the toothed side faces inwards as shown below and make sure that the upper
and lower edges of the belt are fitted in the Latches.
Fig. 3-102
Latches
Head/
CR timing belt
Belt gear
carriage unit

Brother MFC-J2330DW Specifications

General

Brand	Brother
Model	MFC-J2330DW
Category	All in One Printer
Language	English