EasyManuals Logo

BRP Evinrude E-TEC G2 150 HP User Manual

BRP Evinrude E-TEC G2 150 HP
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
23
Boat Rigging
Steering Systems
1
2
Hydraulic Steering Fluid
Refer to Filling and Bleeding the Hydraulic
Steering System on p. 76, for hydraulic fluid rec-
ommendations.
DPS Helm Compatibility
Pro Series Helms
“Pro Series” helms are designed for use on
high-performance boats capable of speeds in
excess of 65 mph (105 kph) with a single,
non-power assisted outboard up to 300 HP.
IMPORTANT: NEVER use Ultraflex SVS or
SeaStar Pro Series helms in multiple outboard in-
stallations.
Other Helms
Helms provided by other manufacturers (for
example Mercury Marine Verado) are NOT com-
patible with the hydraulic steering system of Evin-
rude E-TEC G2 outboards.
Dynamic Power Steering System
Improvements
Improvements have been made to the DPS sys-
tem to support the Evinrude i-Dock steering sys-
tem, Pro Series helms and three or four outboard
installations.
Improvements (DPS-2) are effective beginning
with:
74° V6 – AFA models
66° V6 – AAA models
IMPORTANT: Improvements also effect helm
and outboard selection. Carefully review the fol-
lowing information:
DPS System Compatibility
AB 200 H.O. – 300 HP, 74° V6 ONLY
The DPS-1 system used on ABA model outboards
is NOT compatible with the DPS-2 system used
on 74° V6, AFA and newer model outboards.
Do NOT install ABA and AFA model
DPS-equipped outboards on the same transom.
Pro-Series helms MAY be used in the following
single engine, IHS Evinrude E-TEC 74° V6 ABA
outboard models:
E200LHOABA
E225LHOABA
E250LHOABA
AA & Newer 66° V6 and
AF & Newer 74° V6
Ultraflex SVS or SeaStar Pro Series helms may
be used in single engine installations of the above
model Evinrude E-TEC G2 outboards.
IMPORTANT: Multiple outboard installations
REQUIRE:
correct outboard alignment
steering position sensor calibration.
Refer to Multiple Outboard Installations on
p. 89.
NOTICE
Use ONLY the helms listed in the Recom-
mended Helm Charts on p. 25, when installing
Evinrude E-TEC G2 outboards.
NOTICE
Do NOT use Pro Series helms with a
DPS-equipped ABA model Evinrude E-TEC
G2 outboard.
Use of these helms with DPS-equipped ABA
model will result in damage to the DPS power
steering pump.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BRP Evinrude E-TEC G2 150 HP and is the answer not in the manual?

BRP Evinrude E-TEC G2 150 HP Specifications

General IconGeneral
BrandBRP
ModelEvinrude E-TEC G2 150 HP
CategoryOutboard Motor
LanguageEnglish

Related product manuals