BRP Evinrude E-TEC G2 150 HP User Manual

88
Predelivery
Before Start-up
Before Start-up
Gearcase Lubricant
With outboard vertical, check the gearcase lubri-
cant level:
• Inspect the lubricant level in the lubricant reser-
voir.
• Lubricant level should be between the marks as
shown.
Add HPF PRO gearcase lubricant if needed.
2-Stroke Engine Oil Level
Place the outboard to the vertical position to fill, or
check oil level. Make sure the on-board oil tank
contains an adequate supply of the correct lubri-
cant for the outboard. Refer to Recommended
Lubricants on p. 85.
Trim and Tilt Fluid
The trim and tilt system is filled, tested and sealed
at the factory. It is NOT necessary to check fluid
level.
Check the fluid level ONLY if the trim and tilt is
NOT operating normally.
Refer to the Evinrude E-TEC G2 Service Manual
for the correct method of checking fluid level.
Lubricant reservoir 150 – 200 HP Models
009828
1. Lubricant reservoir
Lubricant reservoir 200 H.O. – 300 HP Models
009140
1. Lubricant reservoir
Lubricant Level (150 HP shown)
1. Maximum
2. Minimum
009829
1
1
2
1
 CAUTION
Correct fluid level must be maintained to
ensure operation of the impact protection
built into the unit.

BRP Evinrude E-TEC G2 150 HP Specifications

General

Brand	BRP
Model	Evinrude E-TEC G2 150 HP
Category	Outboard Motor
Language	English