89
- Host/Device switching between the terminal’s microA/B connectors and the cradle
Micro A/B connector
If the microA connector is attached by the connector contact point signal: Host
If the microB connector is attached: Switch to Device
Cradle
- Use the cradle’s switch to change to A and LAN: Host, B: Device.
- Switching between WAN and external expansion connector
The internal WAN module in a model equipped with W-WAN, and the external expansion terminal,
are used by switching exclusively between them, using the same USB controller. The switching
algorithm is as follows:
- The external expansion connector is selected in normal circumstances
- On W-WAN-equipped models, the WAN power driver is switched to the WAN side for use
(2) USB Function
– Supports USB 1.1 full speed
– Use the tool to select in advance whether to connect using LMWIN or WMDC connection.
– The VID/PID when the choice is made is as follows:
LMWIN WMDC
WEH6.5
VID: 0x07CF
PID: 0x3303
VID: 0x045E
PID: 0x 00CE
(3) USB Host
– Supports USB 1.1 full speed
– The USB device is disconnected when the terminal is suspended.
– Communication via USB HUB is not supported.
To Next Page
Loading...
Need help?
General