CHAPTER 12
Monitoring the System
This chapter provides information for monitoring system status and performance using the show commands
found in the Command Line Interface (CLI). These command have many related keywords that allow them
to provide useful information on all aspects of the system ranging from current software configuration through
call activity and status.
The selection of keywords described in this chapter is intended to provide the most useful and in-depth
information for monitoring the system. For additional information on these and other show command
keywords, refer to the Exec Mode show Commands chapter of the Command Line Interface Reference.
In Release 21.1 and forward, use the do show command to run all Exec Mode show commands while in
Global Configuration Mode. It is not necessary to exit the Config mode to run a show command. The pipe
character | is only available if the command is valid in the Exec mode.
Important
•
SNMP Notifications, page 149
•
Monitoring System Status and Performance, page 149
•
Monitoring ASR 5500 Hardware Status, page 151
•
Clearing Statistics and Counters, page 153
SNMP Notifications
In addition to the CLI, the system supports Simple Network Management Protocol (SNMP) notifications that
indicate status and alarm conditions. Refer to the SNMP MIB Reference for a detailed listing of these
notifications.
Monitoring System Status and Performance
This section contains commands used to monitor the status of tasks, managers, applications and other software
components in the system. Output descriptions for most of the commands are located in the Statistics and
Counters Reference.
ASR 5500 System Administration Guide, StarOS Release 21.4
149
To Next Page
Loading...
Need help?
General
