EasyManuals Logo
Home>Cisco>Network Router>ASR 5500

Cisco ASR 5500 User Manual

Cisco ASR 5500
508 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #412 background imageLoading...
Page #412 background image
A single physical port can support multiple logical interfaces when you configure VLAN tags for that
physical port. You can use VLAN tagging to bind a single physical port to multiple logical interfaces
that reside in different contexts.
Assign all logical interfaces a valid IP address and subnet.
Give each logical interface within a context a unique IP address(es). Logical interfaces in different
contexts can have the same IP address(es).
If multi-homing is supported on the network, you can assign all logical interfaces a single primary
IP address and up to 16 secondary IP addresses.
You can configure a logical interface in only one context, but you can configure multiple interfaces (up
to 512) in a single context.
You can apply a maximum of 256 access control list (ACL) rules to a single logical interface.
All ports are identified by their <slot#>/<port#>.
Each physical port for subscriber traffic on an MIO/UMIO/MIO2 card may contain up to a maximum
of 1,024 VLAN tags.
A logical interface is limited to using a single VLAN on a single physical port, identified by its
<card#/slot#/port#>.
Packet Data Network (PDN) Interface Rules
The following engineering rules apply to the interface to the packet data network (PDN):
Configure the logical interfaces used to facilitate the PDN interface within the egress context.
The default is to use a single interface within the egress context to facilitate the PDN interface.
You can configure multiple interfaces in the egress context by using static routes or dynamic routing
protocols.
You may also configure next-hop default gateways.
Context Rules
A maximum of 63 contexts may be configured per chassis.Enabling demux functions on an MIO card
reduces the maximum number of contexts to 10.
Interfaces per Context
Prior to Release 15.0: Up to 16 interfaces can be configured within a single context.
For Release 15.0 and higher: With the Demux MIO/UMIO/MIO2 feature enabled, up to 64
interfaces can be configured within a single context.
512 Ethernet+PPP+tunnel interfaces
32 ipv6ip tunnel interfaces
511 GRE tunnels (2,048 GRE tunnels per chassis)
ASR 5500 System Administration Guide, StarOS Release 21.4
380
Engineering Rules
Packet Data Network (PDN) Interface Rules

Table of Contents

Other manuals for Cisco ASR 5500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 5500 and is the answer not in the manual?

Cisco ASR 5500 Specifications

General IconGeneral
BrandCisco
ModelASR 5500
CategoryNetwork Router
LanguageEnglish

Related product manuals