Cisco ASR 5500 User Manual

DescriptionCommand
Executes a forced switchover from active to inactive. When executed
on the active chassis, this command switches the active chassis to
the inactive state and the inactive chassis to an active state. See Note
below.
srp initiate-switchover
Resets the auth probe monitor failure information to 0.srp reset-auth-probe-fail
Resets the Diameter monitor failure information to 0.srp reset-diameter-fail
Forcibly terminates post-switchover processing.srp terminate-post-process
Validates the configuration for an active chassis.srp validate-configuration
Validates that both active and standby chassis are ready for a planned
SRP switchover.
srp validate-switchover
For release 20.0 and higher, ICSR will verify session manager connectivity on both chassis prior to allowing
a manual switchover. If one or more of the session managers in the active chassis is not connected on the
standby chassis, the switchover will not be initiated. An error message will appear on the screen noting
the number of session managers that are mismatched. The force keyword can be used to initiate the
switchover despite the mismatch(es). The output of the show checkpoint statistics verbose command
will not indicate "Ready" for a session manager instance ("smgr inst") in the "peer conn" column for any
instance that is not connected to the peer chassis.
Important
show Commands
Exec mode show srp commands display a variety of information related to SRP functions. The table below
lists and briefly describes these commands. For complete information on these commands, see the Exec Mode
show Commands (Q-S) chapter of the Command Line Interface Reference.
Table 45: show srp Commands
DescriptionCommand
Displays statistics of an external audit.show srp audit-statistics
Displays the history of calls lost during switchover.show srp call-loss statistics
Displays check pointing statistics on session redundancy data (session
managers, current call recovery records, etc.).
show srp checkpoint statistics
Displays Service Redundancy Protocol information (context, chassis
state, peer, connection state, etc.).
show srp info
Displays SRP monitor information.show srp monitor
Displays SRP statistics (hello messages sent, configuration validation,
resource messages, switchovers, etc.).
show srp statistics
ASR 5500 System Administration Guide, StarOS Release 21.4
336
Interchassis Session Recovery
SRP CLI Commands

Cisco ASR 5500 Specifications

General

Brand	Cisco
Model	ASR 5500
Category	Network Router
Language	English