Cisco ASR 901 User Manual

1-88
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
payload-size
payload-size
Specifies the size of the payload for packets on a structured CEM channel.
payload-size [payload-size]
Syntax Description
Defaults The default payload size for a structured CEM channel depends on the number of timeslots that
constitute the channel. The default payload size for a T1 is 192 bytes; the default size for an E1 is 256
bytes.
Command Modes CEM circuit configuration
Command History
Examples The following example shows how to specify a sample rate:
Router# config t
Router(config)# interface cem 0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# payload-size 256
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# exit
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
payload-size Specifies the size of the payload for packets on a structured CEM channel.
Valid values are 32–512. The default payload size for a T1 is 192 bytes; the
default size for an E1 is 256 bytes.
Note The payload size must be a multiple of the number of timeslots for
the CEM channel.
The default payload size is calculated as follows:
8 x number of timeslots x 1 ms packetization delay
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English