Cisco ASR 901 User Manual

1-31
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
cpu traffic ppp set ip dscp cs
cpu traffic ppp set ip dscp cs
To re-mark the CPU generated traffic from default value (DSCP CS6) to the desired differentiated
service code point (DSCP) value for QoS treatment, use the cpu traffic ppp set ip dscp cs command on
the global configuration mode. Use the no form of the command to reset matching of packets with DSCP
Certificate Server (CS).
cpu traffic ppp set ip dscp cs
no cpu traffic ppp set ip dscp cs
Syntax Description This command has no arguments or keywords.
Command Default None
Command Modes Global configuration (config)#
Command History
Usage Guidelines This command is used to mark the CPU generated traffic transmitted through MLPPP Interface. It
enables the user to provide desired QoS treatment to CPU generated traffic. The valid values are from
cs1 to cs7.
Examples This example shows how to re-mark the CPU generated traffic from default value to the desired DSCP
value for QoS treatment on a Cisco ASR 901 series router:
Router# configure terminal
Router(config)# cpu traffic ppp set ip dscp cs5
Release Modification
15.4(1)S This command was introduced on the Cisco ASR 901 Series Aggregation
Services Routers.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English