Cisco ASR 901 User Manual

1-79
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
network-clock revertive
network-clock revertive
To configure the clock-source as revertive, use the network-clock revertive command. Use the no form
of the command to remove the configuration.
network-clock revertive
no network-clock revertive
Command Default The default value is non-revertive.
Command Modes Global configuration
Command History
Usage Guidelines T he network-clock revertive command specifies whether or not the clock source is revertive. Clock
sources with the same priority are always non-revertive. The default value is non-revertive.
In non-revertive switching, a switch to an alternate reference is maintained even after the original
reference recovers from the failure that caused the switch. In revertive switching, the clock switches back
to the original reference after that reference recovers from the failure, independent of the condition of
the alternate reference.
Examples This example shows how to make the clock-source revertive:
Router(config)#[no] network-clock revertive
Related Commands
Release Modification
15.1(2)SNG This command was introduced.
Command Description
network-clock
input-source
Configures a clock source line interface, an external timing input interface,
GPS interface, or a packet-based timing recovered clock as the input clock
for the system.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English