Cisco ASR 901 User Manual

1-80
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
network-clock wait-to-restore
network-clock wait-to-restore
Specifies the amount of time in seconds that the Cisco ASR 901 waits before considering a new clock
source. Specify the network-clock wait-to-restore-timeout command in the interface configuration
mode.
network-clock wait-to-restore <0-86400>
no network-clock wait-to-restore <0-86400>
Syntax Description
Defaults The default setting is network-clock-select wait-to-restore 300.
Command Modes Interface configuration mode.
Command History
Usage Guidelines The wait to restore time is configurable in the range of 0 to 86400 seconds. The default value is 300
seconds.
Caution Ensure that you set the wait-to-restore values above 50 seconds to avoid a timing flap.
Examples The following example shows how to use the network-clock wait-to-restore command:
Router# config t
Router(config-if)# network-clock wait-to-restore 1000 global
Router(config-if)# exit
Related Commands
<0-86400> The wait to restore time is configurable in the range of 0 to 86400 seconds.
The default value is 300 seconds.
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.
Command Description
set network-clocks
force-reselect
Forces the router to re-select the network clock.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English