Cisco ASR 901 User Manual

1-197
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
synce state slave
synce state slave
To configure the synchronous ethernet copper port as slave, use the synche state slave command. Use
the no form of the command to disable the configuration.
synce state slave
no synce state slave
Syntax Description This command has no arguments.
Command Default None.
Command Modes Interface configuration mode.
Command History
Usage Guidelines The synce state slave command configures the synchronous ethernet copper port as the slave in the
interface configuration mode.
Examples The following command configures the ethernet copper port as slave:
Router(config-if)# synce state slave
Related Commands
Release Modification
15.1(2)SNG This command was introduced on the Cisco ASR 901 router.
Command Description
synce state master Configures the synchronous ethernet copper port as master.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English