Cisco ASR 901 User Manual

1-204
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
xconnect logging redundancy
xconnect logging redundancy
To enable system message log (syslog) reporting of the status of the xconnect redundancy group, use the
xconnect logging redundancy command in global configuration mode. To disable syslog reporting of
the status of the xconnect redundancy group, use the no form of this command.
xconnect logging redundancy
no xconnect logging redundancy
Syntax Description This command has no arguments or keywords.
Defaults Syslog reporting of the status of the xconnect redundancy group is disabled.
Command Modes Global configuration
Command History
Usage Guidelines Use this command to enable syslog reporting of the status of the xconnect redundancy group.
Examples The following example enables syslog reporting of the status of the xconnect redundancy group and
shows the messages that are generated during switchover events:
Router# config t
Router(config)# xconnect logging redundancy
Router(config)# exit
Activating the Primary Member
00:01:07: %XCONNECT-5-REDUNDANCY: Activating primary member 10.55.55.2:1000
Activating the Backup Member:
00:01:05: %XCONNECT-5-REDUNDANCY: Activating secondary member 10.55.55.3:1001
Related Commands
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.
Command Description
xconnect Binds an Ethernet, 802.1q VLAN, or Frame Relay attachment circuit
to an Layer 2 PW for xconnect service and enters xconnect
configuration mode.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English