Cisco ASR 901 User Manual

1-45
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
esmc mode
esmc mode
To enable or disable ESMC process on the interface, use the esmc mode command in interface
configuration mode. Use the no form of this command to disable the configuration
esmc mode <tx | rx >
no esmc mode
Syntax Description
Command Default Enabled for synchronous mode and disabled for asynchronous mode.
Command Modes Interface configuration (config-if)
Command History
Usage Guidelines If the interface is configured as line source but does not receive ESMC message from peer node on the
interface, then the interface is removed from selectable clock source list. By default this is enabled for
synchronous mode and disabled for asynchronous mode.
Note This command is not supported for non-synchronous ethernet interfaces.
Examples The following example shows how to enable ESMC process:
Router(config-if)#esmc mode tx
Related Commands
tx Transmission mode
rx Receiving mode
Release Modification
15.1(2)SNG Support for this command was introduced on the Cisco ASR 901 router.
Command Description
esmc process Enables the ESMC process in a router.
show esmc Displays the enabled ESMCs in a router.
show interfaces accounting Displays the number of packets of each protocol type that have been
sent through all configured interfaces.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English