Cisco ASR 901 User Manual

1-16
Cisco ASR 901 Aggregation Services Router Command Reference Guide
OL-26031-07
Chapter 1 CLI Command Reference
asr901-platf-multi-nni-cfm
asr901-platf-multi-nni-cfm
To enable the multi-Network-to-Network Interface Connectivity Fault Management (multi-NNI CFM)
configuration, use the asr901-platf-multi-nni-cfm command. Use the no form of the command to
enable the Synthetic Loss Measurement (SLM) over cross connect EVC configuration.
asr901-platf-multi-nni-cfm
no asr901-platf-multi-nni-cfm
Syntax Description This command has no arguments or keywords.
Command Default This command is enabled by default.
Command Modes Global configuration (config)#
Command History
Usage Guidelines This command is used to enable multi-NNI CFM configuration or SLM over cross connect EVC
configuration on a Cisco ASR 901 router. You can configure by enabling or disabling the command. By
default, the multi-NNI CFM configuration is enabled. When you run the required command , a syslog is
generated so that you can save the configuration and reload the router. You should reload the router after
using the asr901-multi-nni-cfm command or no form of the command.
Examples This example shows how to enable multi-NNI CFM over cross connect EVC configuration on a
CiscoASR901router:
Router# configure terminal
Router(config)# asr901-platf-multi-nni-cfm
This example shows how to enable SLM over cross connect EVC configuration on a
CiscoASR901router:
Router# configure terminal
Router(config)# no asr901-platf-multi-nni-cfm
Release Modification
15.3(3)S This command was introduced on the Cisco ASR 901 Series Aggregation
Services Routers.

Cisco ASR 901 Specifications

General

Brand	Cisco
Model	ASR 901
Category	Network Router
Language	English