PurposeCommand or Action
(Optional) Enables the VLAN for which this access port
carries traffic and sets the interface as a nontrunking
nontagged single-VLAN Ethernet interface.
switchport access vlan vlan_id
Example:
Device(config)# interface GigabitEthernet1/0/1
Step 10
This step is to be configured only if the
switchport access mode is required.
Note
Device(config-if)# switchport access vlan 100
Device(config-if)# switchport mode access
Device(config-if)# exit
Device(config)#
Configures a route on the device.ip route ip-address ip-mask subnet mask
Step 11
Example:
You can configure either a static route or a
dynamic route.
Note
Device(config)# ip route 192.0.2.0 255.255.255.255
192.0.2.1
Enables the transport mode as Call Home.license smart transport callhome
Step 12
Example:
The license smart transport callhome
command is mandatory.
Note
Device(config)# license smart transport callhome
Configures a source interface for the HTTP client.ip http client source-interface interface-type
interface-number
Step 13
The ip http client source-interface
interface-type interface-number command is
mandatory.
Note
Example:
Device(config)# ip http client source-interface
Vlan100
(Optional) Exits global configuration mode and returns to
privileged EXEC mode.
exit
Example:
Step 14
Device(config)# exit
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Step 15
Device# copy running-config startup-config
Configuring the Call Home Service for Direct Cloud Access
By default, the CiscoTAC-1 profile is already set up on the device. Use the show call-home profile all
command to check the profile status.
Note
The Call Home service provides email-based and web-based notification of critical system events to CSSM.
To configure and enable the Call Home service, perform this procedure:
SUMMARY STEPS
1. enable
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
90
Configuring Smart Licensing
Configuring the Call Home Service for Direct Cloud Access
To Next Page
Loading...
Need help?
General