Cisco Catalyst 9200 User Manual

PurposeCommand or Action
• copy nvram:startup-config rcp:
[[[//[username@]location ]/directory ]/filename ]
• Specifies that the device startup configuration file is
to be stored on an RCP server
Example:
Device# copy system:running-config rcp:
//NetAdmin1@example.com/dir-files/file1
Examples
Storing a Running Configuration File on an RCP Server
The following example copies the running configuration file named runfile2-confg to the netadmin1 directory
on the remote host with an IP address of 172.16.101.101:
Device# copy system:running-config rcp://netadmin1@172.16.101.101/runfile2-confg
Write file runfile2-confg on host 172.16.101.101?[confirm]
Building configuration...[OK]
Connected to 172.16.101.101
Device#
Storing a Startup Configuration File on an RCP Server
The following example shows how to store a startup configuration file on a server by using RCP to copy the
file:
Device# configure terminal
Device(config)# ip rcmd remote-username netadmin2
Device(config)# end
Device# copy nvram:startup-config rcp:
Remote host[]? 172.16.101.101
Name of configuration file to write [start-confg]?
Write file start-confg on host 172.16.101.101?[confirm]
![OK]
What to Do Next
After you have issued the copy EXEC command, you may be prompted for additional information or for
confirmation of the action. The prompt displayed depends on how much information you provide in the copy
command and the current setting of the file prompt global configuration command.
Copying a Configuration File from the Device to the FTP Server
To copy a startup configuration file or a running configuration file from the device to an FTP server, complete
the following tasks:
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
155
Managing Configuration Files
Examples

Cisco Catalyst 9200 Specifications

General

Brand	Cisco
Model	Catalyst 9200
Category	Switch
Language	English