Cisco Catalyst 9200 User Manual

SUMMARY STEPS
1. switch:BOOT=<source path of .bin file>
2. boot
3. show version
DETAILED STEPS
PurposeCommand or Action
Sets the boot parameters.switch:BOOT=<source path of .bin file>
Example:
Step 1
Boots the device.boot
Step 2
Example:
switch: boot
Verifies that the device is in the BUNDLE mode.show version
Step 3
Configuring a Scheduled Software Image Reload
This task describes how to configure your device to reload the software image at a later time.
SUMMARY STEPS
1. configure terminal
2. copy running-config startup-config
3. reload in [hh:]mm [text]
4. reload at hh: mm [month day | day month] [text]
5. reload cancel
6. show reload
DETAILED STEPS
PurposeCommand or Action
Enters global configuration mode.configure terminal
Example:
Step 1
Device# configure terminal
Saves your device configuration information to the startup
configuration before you use the reload command.
copy running-config startup-config
Example:
Step 2
Device# copy running-config startup-config
Schedules a reload of the software to take affect in the
specified minutes or hours and minutes. The reload must
reload in [hh:]mm [text]
Example:
Step 3
take place within approximately 24 days. You can specify
Device# reload in 12
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
74
Performing Device Setup Configuration
Configuring a Scheduled Software Image Reload

Cisco Catalyst 9200 Specifications

General

Brand	Cisco
Model	Catalyst 9200
Category	Switch
Language	English