Cisco Catalyst 9200 User Manual

Some specific commands might not get saved to NVRAM. You need to enter these commands again
if you reboot the machine. These commands are noted in the documentation. We recommend that
you keep a list of these settings so that you can quickly reconfigure your device after rebooting.
Note
Copying a Configuration File from the Device to a TFTP Server
To copy configuration information on a TFTP network server, complete the tasks in this section:
SUMMARY STEPS
1. enable
2. copy system:running-config tftp: [[[//location ]/directory ]/filename ]
3. copy nvram:startup-config tftp: [[[//location ]/directory ]/filename ]
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
• Enter your password if prompted.
Device> enable
Copies the running configuration file to a TFTP server.copy system:running-conf ig tftp: [[[//location ]/directory
]/filename ]
Step 2
Example:
Device# copy system:running-config tftp:
//server1/topdir/file10
Copies the startup configuration file to a TFTP server.copy nvram:startup-config tftp: [[[//location ]/directory
]/filename ]
Step 3
Example:
Device# copy nvram:startup-config tftp:
//server1/1stdir/file10
Examples
The following example copies a configuration file from a device to a TFTP server:
Device# copy system:running-config tftp://172.16.2.155/tokyo-confg
Write file tokyo-confg on host 172.16.2.155? [confirm] Y
Writing tokyo-confg!!! [OK]
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
153
Managing Configuration Files
Copying a Configuration File from the Device to a TFTP Server

Cisco Catalyst 9200 Specifications

General

Brand	Cisco
Model	Catalyst 9200
Category	Switch
Language	English