PurposeCommand or Action
• test-id-range—ID numbers of the tests that appear in
the show diagnostic content command output.
• all—All test IDs.
• basic—Starts the basic on-demand diagnostic tests.
• complete—Starts the complete test suite.
• minimal—Starts the minimal bootup test suite.
• non-disruptive—Starts the non-disruptive test suite.
• per-port—Starts the per-port test suite.
You can schedule the tests as follows:
• Daily—Use the daily hh:mm parameter.
• Specific day and time—Use the on mm dd yyyy hh:mm
parameter.
• Weekly—Use the weekly day-of-week hh:mm
parameter.
Configuring Health-Monitoring Diagnostics
You can configure health-monitoring diagnostic testing on a Device while it is connected to a live network.
You can configure the execution interval for each health-monitoring test, enable the Device to generate a
syslog message because of a test failure, and enable a specific test.
Use the no form of this command to disable testing.
By default, health monitoring is disabled, but the Device generates a syslog message when a test fails.
Follow these steps to configure and enable the health-monitoring diagnostic tests:
SUMMARY STEPS
1. enable
2. configure terminal
3. diagnostic monitor interval number test {name | test-id | test-id-range | all} hh:mm:ss milliseconds
day
4. diagnostic monitor syslog
5. diagnostic monitor threshold number number test {name | test-id | test-id-range | all} failure count
count
6. diagnostic monitor number test {name | test-id | test-id-range | all}
7. end
8. show diagnostic { content | post | result | schedule | status | }
9. show running-config
10. copy running-config startup-config
System Management Configuration Guide, Cisco IOS XE Gibraltar 16.10.x (Catalyst 9200 Switches)
137
Configuring Online Diagnostics
Configuring Health-Monitoring Diagnostics
To Next Page
Loading...
Need help?
General