EasyManuals Logo
Home>Cisco>Switch>SF500-24

Cisco SF500-24 User Manual

Cisco SF500-24
548 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #100 background imageLoading...
Page #100 background image
6
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 82
Administration: General Information
This section describes how to view system information and configure various
options on the device.
It covers the following topics:
• Device Models
• System Information
• Console Settings (Autobaud Rate Support)
• Rebooting the Device
• Routing Resources
• Monitoring Fan Status
• Defining Idle Session Timeout
• Pinging a Host
• Traceroute
Device Models
All models can be fully managed through the web-based switch configuration
utility.
NOTE Each model can be set to Layer 3 system mode by using the System Mode and
Stack Management page, except for the SG500X/ESW2-550X models that always
run in both Layer 2 and Layer 3 system mode.
When the device operates in Layer 3 system mode, the VLAN Rate Limit, and QoS
policers are not operational. Other QoS Advanced mode features are operational.
Only the SG500X/ESW2-550X models support Virtual Router Redundancy
Protocol (VRRP), and Routing Information Protocol (RIP).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SF500-24 and is the answer not in the manual?

Cisco SF500-24 Specifications

General IconGeneral
BrandCisco
ModelSF500-24
CategorySwitch
LanguageEnglish

Related product manuals