10
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 152
Port Management
This section describes port configuration, link aggregation, and the Green
Ethernet feature.
It covers the following topics:
• Configuring Ports
• Setting Port Configuration
• Configuring Link Aggregation
• Configuring Green Ethernet
Configuring Ports
To configure ports, perform the following actions:
1. Configure port by using the Port Settings page.
2. Enable/disable the Link Aggregation Control (LAG) protocol, and configure the
potential member ports to the desired LAGs by using the LAG Management
page. By default, all LAGs are empty.
3. Configure the Ethernet parameters, such as speed and auto-negotiation for the
LAGs by using the LAG Settings page.
4. Configure the LACP parameters for the ports that are members or candidates
of a dynamic LAG by using the LACP page.
5. Configure Green Ethernet and 802.3 Energy Efficient Ethernet by using the
Properties page.
6. Configure Green Ethernet energy mode and 802.3 Energy Efficient Ethernet per
port by using the Port Settings page.
7. If PoE is supported and enabled for the device, configure the device as
described in Port Management: PoE.
To Next Page
Loading...
Need help?
General
