Security
SSL Server
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 386
20
• Interface—Enter the interface number.
• Applies to Source IP Address—Select the type of source IP address to
which the access profile applies. The Source IP Address field is valid for a
subnetwork. Select one of the following values:
- All—Applies to all types of IP addresses.
- User Defined—Applies to only those types of IP addresses defined in
the fields.
• IP Version—Select the supported IP version of the source address: IPv6 or
IPv4.
• IP Address—Enter the source IP address.
• Mask—Select the format for the subnet mask for the source IP address, and
enter a value in one of the field:
- Network Mask—Select the subnet to which the source IP address
belongs and enter the subnet mask in dotted decimal format.
- Prefix Length—Select the Prefix Length and enter the number of bits that
comprise the source IP address prefix.
STEP 5 Click Apply, and the rule is added to the access profile.
SSL Server
This section describes the Secure Socket Layer (SSL) feature.
SSL Overview
The Secure Socket Layer (SSL) feature is used to open an HTTPS session to the
device.
An HTTPS session may be opened with the default certificate that exists on the
device.
Some browsers generate warnings when using a default certificate, since this
certificate is not signed by a Certification Authority (CA). It is best practice to have
a certificate signed by a trusted CA.
To Next Page
Loading...
Need help?
General
