Cisco UCS X9508 User Manual

Installing the Rails
Before you begin
Make sure that you have marked the correct cage nut and rail locations on the rack by using the illustrations
of the rack installation templates. See Rail Installation Templates, on page 27.
Step 1 Adjust the length of the rail by sliding the ends of the rail back and forth until they match the depth of the rack.
Step 2 At the front of the rack, use the front installation template to position the two locator pegs on the rail with the corresponding
location in the rack. See Front Install Template, on page 27.
The locator pegs will hold the rail in the rack so that you don't have to hold the rail in place.
Step 3 At the rear of the rack, use the rear installation template to position the two locator pegs on the rail with the corresponding
location in the rack. See Rear Install Template, on page 28.
Step 4 Repeat the previous steps to install the other rack rail.
Figure 14: Install Rails into Front of the Rack
Step 5 (Optional) Use a tape measure and level to verify that the rack rails are horizontal and at the same height.
Step 6 At the front of the rack, refer to the template, then insert a screw in each front rail to secure each rail to the rack at the
correct location.
Cisco UCS X9508 Server Chassis Installation Guide
33
Installation
Installing the Rails

Cisco UCS X9508 Specifications

General

Brand	Cisco
Model	UCS X9508
Category	Server
Language	English