InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
13.1.5 List of possible alarms
Information on binary
output available (See
list of Binary outputs)
Oil pressure is smaller than Wrn Oil
press setpoint.
Oil pressure is smaller than Sd Oil
press setpoint.
No information about the oil pressure
from the binary oil pressure sensor.
Water temperature is greater than
Wrn Water temp setpoint.
Water temperature is greater than Sd
Water temp setpoint.
Fuel level is smaller than Wrn Fuel
Level setpoint.
Fuel level is smaller than Sd Fuel
Level setpoint.
Battery voltage is out of limits given by
Batt overvolt and Batt undervolt
setpoints.
Warning alarm configurable on the
input of the controller
Shutdown alarm configurable on the
input of the controller.
Warning alarm configurable on the
input of plug-in.
Shutdown alarm configurable on the
input of plug-in.
Configurable Warning/Shutdown
alarms on the inputs of InteliDrive Lite.
If the controller switches off during
starting sequence due to bad battery
condition it doesn’t try to start again
and activates this protection.
At least one running condition was
detected (Poil>Starting POil or
energized D+) and do not appear
RPM>Starting RPM.
Wrong checksum of parameters.
Happens typically after downloading
new firmware or changing of the
parameter. The controller stays in
INIT mode. Check all parameters,
write at least one new parameter.
The protection comes active if the
speed is greater than Overspeed
setpoint.
During starting of the engine when the
RPM reached the value of Starting
RPM setpoint the starter is switched
off and the speed of the engine can
drop under Start RPM again. Then the
Underspeed protection becomes
active. Protection evaluation starts 5
seconds after reaching StartingRPM.
If the input Emergency stop is opened
To Next Page
Loading...
Need help?
General
