ComAp InteliDrive Lite Reference Guide

InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
83
7.4.21 MaxSpeedLim [RPM]
The setpoint presets the maximum engine speed in the “Running” operation state. Also see other
conditions in the chapter below.
Step: 1RPM
Range: MinSpeedLim - 4000RPM
Default: 2700RPM
7.4.22 BI Speed Sel 1 [RPM]
The setpoint presets the required engine speed during the ‘Speed Sel 1’ binary input is active.
Function depends on RetToSpeedAdj setting.
Step: 1 RPM
Range: MinSpeedLim - MaxSpeedLim
Default: 1250 RPM
7.4.23 BI Speed Sel 2 [RPM]
The setpoint presets the required engine speed during the ‘Speed Sel 2’ binary input is active.
Function depends on RetToSpeedAdj setting.
Step: 1 RPM
Range: MinSpeedLim - MaxSpeedLim
Default: 1300 RPM
7.4.24 BI Speed Sel 3 [RPM]
The setpoint presets the required engine speed during the ‘Speed Sel 3’ binary input is active.
Function depends on RetToSpeedAdj setting.
Step: 1 RPM
Range: MinSpeedLim - MaxSpeedLim
Default: 1450 RPM
HINT
When none of the binary inputs: ‘Speed Sel1’, ‘Speed Sel2’ and ‘Speed Sel3’, ‘Speed Up’ and ‘Speed
Down’ has not been configured then engine speed is given by the ‘Engine params: ECU SpeedAdj‘
setpoint.
7.4.25 Speed Ramp [RPM/s]
Any Speed request change is done via this Ramp function. The Ramp via Binary SpeedUp and
SpeedDown inputs is dual rate, see below.

ComAp InteliDrive Lite Specifications

General

Brand	ComAp
Model	InteliDrive Lite
Category	Controller
Language	English