ComAp InteliDrive Lite Reference Guide

InteliDrive Lite, SW version 1.9
ID-FLX-Lite-1.9r1 Reference Guide.pdf, ©ComAp – August 2015
71
7 Setpoints
Configuration of Setpoints is possible through panel buttons as is described above or via ComAp PC
tool LiteEdit, where the setting can be open by click on the icon .
7.1 Password
7.1.1 EnterPassword
Password is a four-digit number. Password enables change of relevant protected set points Use  or
 keys to set and ENTER key to enter the password. There are 3 levels of passwords. Knowledge of
higher password lets you to change setpoint protected by lower password.
7.1.2 ChangePassword
Use  or  button to set and ENTER button to change the password.
HINT
At first the Password has to be entered before the new Password can be changed.
Can be used LiteEdit PC tool for changes of Password level in window Modify press button
Password for each of three levels can be adjusted from the menu Controller->Change password…
7.2 Basic settings
7.2.1 Engine name
User defined name, used for engine – InteliDrive Lite identification at remote phone or mobile
connection.
Engine name is maximally 14 characters long and have to be entered using LiteEdit software.
7.2.2 Gear teeth [-]
The number of teeth on the engine gear for the pick-up sensor. The setpoint is ignored when ECU is
configured.
NOTE:
The RPM pickup input is ignored when Engine params: Gear teeth = 0. The engine running state is
then detected based on Engine params: Starting Oil or Engine params: D+ function = ENABLED.
Step: 1
Range: 0 - 500

ComAp InteliDrive Lite Specifications

General

Brand	ComAp
Model	InteliDrive Lite
Category	Controller
Language	English