Programming Manual 102
11.1 Virtual Circuit ($JCONN,AB)
The commands described in this section require the issue of the virtual
circuit command, $JCONN,AB discussed in Chapter 3. This command
establishes a direct connection to the microprocessor that operates the
menu system of the DGPS MAX receiver.
11.2 $PCSI,HELP
This command provides a listing of the available commands for use and has
the following definition:
$PCSI,HELP<CR><LF>
The DGPS MAX will respond with the following data output:
$>PCSI,Version,P022-x.xxx
$>PCSI,HELP -Help message
$>PCSI,BAUD, -Baud Rate
$>PCSI,SETUP,SET, -LL,HGT,SPD,UTC,SRC,RT
$>PCSI,SETUP,SHOW -Shows Setup
$>PCSI,SETUP,MUX -Enable/Disable Communication Mux
$>PCSI,STATUS,CS -Checksum Error Report
Where ‘x.xxx’ is the current menu system version number.
11.3 $PCSI,BAUD
The $PCSI,BAUD command is used to change the DGPS MAX’s baud rate
and has the following structure:
$PCSI,BAUD,baud<CR><LF>
Where ‘baud’ is the following valid baud rates.
To Next Page
Loading...
Need help?
General
