Programming Manual 108
12. Configuration Wizard (for
DGPS MAX only)
The Configuration Wizard is a useful feature that allows you to choose pre-
defined configurations for DGPS MAX operation. You may choose a user-
defined profile upon start-up or may choose to enter the Configuration
Wizard at any time during receiver operation. The Configuration Wizard is
described in detail in Chapter 6 of the DGPS MAX Reference Manual.
There are two main parts to the Configuration Wizard: you may choose to
configure the DGPS MAX easily, step-by-step, or you may choose a pre-
defined profile from one of the five saved in memory. Since the DGPS MAX
is shipped with no pre-defined profiles, it’s advantageous to define the
configurations as you feel necessary.
Using pre-defined configurations in the field is especially advantageous when
more than one DGPS MAX receiver is being used in the field by different
people for different purposes. A configuration may be easily selected in the
field with just a few keystrokes, customizing the DGPS MAX for the task at
hand.
You may define the configurations either by using the menu system or you
may use a NMEA command. Using the menu system is a convenient method
of defining the profiles, however, it may be more efficient to define the
profiles once in a terminal program, and then configure the Wizard through
the serial port for the DGPS MAX. This is the preferred method if many
DGPS MAX receivers need to be configured with the same profiles for
consistency throughout a pool of receivers.
This section presents various commands relating to setup of the
Configuration Wizard through the serial port. This allows you to pre-
configure the Wizard configurations before the receiver goes into the field,
according to your specific needs.
To Next Page
Loading...
Need help?
General
